SEP60 RAIL
OIL WATER SEPARATOR
Single-use, quick-fit condensate cleaner for compressed air systems up to 60cfm (1.7 m³/min)*
-
Rail
-
Tube
-
Tram
Our proprietary SILEXA™ filter medium gives SEP 60 the capacity to out-perform separators twice its size. And it’s pure simplicity to install and replace. Just fix the permanent back plate to a wall or compressor cabinet, insert two push-in quick fittings and it starts to protect you - and the environment.
Oily water in; clean water out. Discharge levels less than 5ppm.
At the end of its service life, simply remove the push fittings, attach the clip-on lid and plug (provided with the replacement unit) and slide it off the wall plate. Captured oil Is sealed inside the separator, which is now ready for transport and disposal.
More InfoThroughout thorough trials this patented media has been shown to be lighter, 20% more absorbent per weight and cleaner compared to other OEM products.
More About SilexaThe unit comes shipped with a 6mm inlet as standard.
We can also supply a 1/4” inlet as an option. Please state when ordering if you would prefer this fitting.
* SEP60 is rated for use on compressor systems using mineral or mineral-based lubricants.
Contact SEPURA regarding PAG lubricants, but in any case de-rate by at least 50%.
** It is the user’s responsibility to verify discharge allowances in their region
*** Assumes compressor oil carry-over is no more than 5mg/m³
© Copyright Sepura 2025. All Rights Reserved.